Member of Technical Staff - Electronics Engineer, Actuators & Drives, Frontier AI & Robotics

Join Amazon's Frontier AI & Robotics team and take ownership of the electronics that make our robots move. As a Member of Technical Staff - Electronics Engineer, Actuators & Drives, you will conceptualize, design, and test the motor drive electronics that power our in-house robotic actuators—from the gate drivers and power stages that command motor current to the sensing circuits and communication interfaces that give our robots proprioceptive awareness. Your printed circuit board (PCB) designs will live inside each of our next-generation robotic systems, directly enabling the embodied intelligence that is central to FAR's mission. Key job responsibilities

• Conceptualize, design, and validate motor drive electronics for in-house robotic actuators, including inverter power stages, gate driver circuits, current and position sensing, and power management subsystems from concept through prototype and production • Lead PCB-level design of compact, high-power-density motor drive boards, including schematic capture, component selection, and collaboration with PCB layout engineers to achieve signal integrity, thermal, and EMC requirements in constrained actuator form factors • Characterize and optimize inverter switching performance, efficiency, and thermal behavior across the full operating envelope of FAR's actuator variants, using bench measurements and simulation to guide design decisions • Define and implement current sensing architectures (shunt-based, Hall-effect, or integrated IC-based) and position/velocity sensing interfaces (encoder, resolver, Hall sensor) to support high-bandwidth FOC firmware on microcontrollers and DSPs • Partner with firmware engineers to define hardware-software interfaces for motor drive control loops, fault detection logic, and communication protocols (CAN, EtherCAT, SPI), ensuring electronics designs support the real-time control requirements of robotic actuation • Collaborate with motor design and mechanical engineers to specify the electrical characteristics of custom BLDC and PMSM motors, align inverter design to motor parameters, and validate the integrated actuator electro-mechanical system • Lead hardware bring-up, functional testing, and failure analysis for new actuator electronics prototypes, developing test plans and characterization setups that systematically validate design performance and identify failure modes • Define electronics design standards, review processes, and design-for-manufacturability (DFM) guidelines for FAR's actuator drive portfolio, and mentor junior engineers in motor drive electronics design best practices